Sigma Phi Epsilon - ΣΦΕ Fraternity Ratings at UPenn

Sigma Phi Epsilon - ΣΦΕ Fraternity at University of Pennsylvania - UPenn 75 2.65
  • Total Ratings: 75
  • Overall Average:53%

Information

Ratings

  • Reputation:Smart
  • Friendliness:42.6%
  • Popularity:50.2%
  • Classiness:52.6%
  • Involvement:50.6%
  • Social Life:54.4%
  • Brotherhood:53.6%
  • 75 Ratings
NEW!  Be notified when someone leaves a new rating! Alert Me
Page 2 of 8
Sigma Phi Epsilon - ΣΦΕ Fraternity at University of Pennsylvania - UPenn 1.0 ure is not too cold, otherwise indoors. It is built up exactlyas was the flower jar in Chapter II., except that there is no cardboardoutline to test it; the eye alone is the guide. Great care should b
1.0
BOTTOM TIER
By: can showPosted:

ure is not too cold, otherwise indoors. It is built up exactlyas was the flower jar in Chapter II., except that there is no cardboardoutline to test it; the eye alone is the guide. Great care should b

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Sigma Phi Epsilon - ΣΦΕ Fraternity at University of Pennsylvania - UPenn 1.0 ve a sturdy, short leg an inch and a halfwide at each of the four corners of the dish.A roll of clay about five and a half inches long, an inch wide, andthree-eighths of an inch thick is made into a h
1.0
BOTTOM TIER
By: ed hangiPosted:

ve a sturdy, short leg an inch and a halfwide at each of the four corners of the dish.A roll of clay about five and a half inches long, an inch wide, andthree-eighths of an inch thick is made into a h

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Sigma Phi Epsilon - ΣΦΕ Fraternity at University of Pennsylvania - UPenn 1.0 und a good clay, potters rarely change. In fact, this feeling is sostrong with some that it amounts almost to a superstition. A potterwho has obtained a clay that is satisfactory in a certain State wi
1.0
BOTTOM TIER
By: ght-grayPosted:

und a good clay, potters rarely change. In fact, this feeling is sostrong with some that it amounts almost to a superstition. A potterwho has obtained a clay that is satisfactory in a certain State wi

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Sigma Phi Epsilon - ΣΦΕ Fraternity at University of Pennsylvania - UPenn 1.0 e form is as nearly a hemisphere aspossible, only flattened slightly at the bottom.When the bowl has been built up to within an inch, perhaps, of the topof the mould, if it is not a deep one, make the
1.0
BOTTOM TIER
By: technicPosted:

e form is as nearly a hemisphere aspossible, only flattened slightly at the bottom.When the bowl has been built up to within an inch, perhaps, of the topof the mould, if it is not a deep one, make the

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Sigma Phi Epsilon - ΣΦΕ Fraternity at University of Pennsylvania - UPenn 1.0 IV METHODS OF DECORATIONThe more simple and strong pottery designs are, the better. Those thatare intricate, no matter how beautiful, are out of place on the big,substantial f
1.0
BOTTOM TIER
By: -white sPosted:

IV METHODS OF DECORATIONThe more simple and strong pottery designs are, the better. Those thatare intricate, no matter how beautiful, are out of place on the big,substantial f

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
↓ Posts Continued Below ↓

NEW ON GREEKRANK

Sigma Phi Epsilon - ΣΦΕ Fraternity at University of Pennsylvania - UPenn 1.0 cisethe outline still deeper. Make a clean-cut, firm outline, broad anddeep, with a bevelled edge. This is, of course, supposing that the tilehas not become very dry, in which case the tool used shoul
1.0
BOTTOM TIER
By: ddle finPosted:

cisethe outline still deeper. Make a clean-cut, firm outline, broad anddeep, with a bevelled edge. This is, of course, supposing that the tilehas not become very dry, in which case the tool used shoul

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Sigma Phi Epsilon - ΣΦΕ Fraternity at University of Pennsylvania - UPenn 1.0 y on to the base.[Illustration: FIG. 26]A piece of clay is then rolled and flattened into a handle an inchin diameter and five inches long. This is put on at one corner ofthe base, and is not attached
1.0
BOTTOM TIER
By: ough. AfPosted:

y on to the base.[Illustration: FIG. 26]A piece of clay is then rolled and flattened into a handle an inchin diameter and five inches long. This is put on at one corner ofthe base, and is not attached

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Sigma Phi Epsilon - ΣΦΕ Fraternity at University of Pennsylvania - UPenn 1.0 suggests one delightful way of utilising this ware.Foliage plants of any size, from a tiny cactus, which seems to finda bowl with a rounded base the most comfortable of abiding places,to a great spre
1.0
BOTTOM TIER
By: ther, anPosted:

suggests one delightful way of utilising this ware.Foliage plants of any size, from a tiny cactus, which seems to finda bowl with a rounded base the most comfortable of abiding places,to a great spre

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Sigma Phi Epsilon - ΣΦΕ Fraternity at University of Pennsylvania - UPenn 1.0 are moulded into a gradual inwardcurve, and the corners are slightly depressed (see plate). A cupfor the candle (see Fig. 26) is made by rolling a piece of clay intocylindrical form, about an inch and
1.0
BOTTOM TIER
By: on: FIG.Posted:

are moulded into a gradual inwardcurve, and the corners are slightly depressed (see plate). A cupfor the candle (see Fig. 26) is made by rolling a piece of clay intocylindrical form, about an inch and

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Sigma Phi Epsilon - ΣΦΕ Fraternity at University of Pennsylvania - UPenn 1.0 oil isadded in the same way. The third coil is brought in a little towardthe centre, and subsequent coils come in still more, so as to make theform that of a jar cut exactly in half. After each coil i
1.0
BOTTOM TIER
By: ter intoPosted:

oil isadded in the same way. The third coil is brought in a little towardthe centre, and subsequent coils come in still more, so as to make theform that of a jar cut exactly in half. After each coil i

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Nickname:
Message:
Robot Check
Enter the text in the image in the box below.
CAPTCHA code

YOU MAY ALSO LIKE

POPULAR ON GREEKRANK

Didn't find your school?Request for your school to be featured on GreekRank.