Kappa Sigma - ΚΣ Fraternity Ratings at UPenn

Kappa Sigma - ΚΣ Fraternity at University of Pennsylvania - UPenn 67 2.57
  • Total Ratings: 67
  • Overall Average:51.4%

Information

Ratings

  • Reputation:Smart
  • Friendliness:29.4%
  • Popularity:52.8%
  • Classiness:52.6%
  • Involvement:44.8%
  • Social Life:55.2%
  • Brotherhood:51%
  • 67 Ratings
NEW!  Be notified when someone leaves a new rating! Alert Me
Page 3 of 7
Kappa Sigma - ΚΣ Fraternity at University of Pennsylvania - UPenn 1.0 press the clay firmly against the walls of themould, as well as upon the coil below. When the inside of the mould iscovered, if a deeper bowl is desired, add one or two more coils abovethe edge, takin
1.0
BOTTOM TIER
By: a bevellPosted:

press the clay firmly against the walls of themould, as well as upon the coil below. When the inside of the mould iscovered, if a deeper bowl is desired, add one or two more coils abovethe edge, takin

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Kappa Sigma - ΚΣ Fraternity at University of Pennsylvania - UPenn 1.0 ure is not too cold, otherwise indoors. It is built up exactlyas was the flower jar in Chapter II., except that there is no cardboardoutline to test it; the eye alone is the guide. Great care should b
1.0
BOTTOM TIER
By: no practPosted:

ure is not too cold, otherwise indoors. It is built up exactlyas was the flower jar in Chapter II., except that there is no cardboardoutline to test it; the eye alone is the guide. Great care should b

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Kappa Sigma - ΚΣ Fraternity at University of Pennsylvania - UPenn 1.0 ottery as well as in other things, and freakishforms which please us to-day may be ridiculed to-morrow; but primitivewares have an enduring value. Pieces that were moulded for service,by potters whose
1.0
BOTTOM TIER
By: nd the dPosted:

ottery as well as in other things, and freakishforms which please us to-day may be ridiculed to-morrow; but primitivewares have an enduring value. Pieces that were moulded for service,by potters whose

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Kappa Sigma - ΚΣ Fraternity at University of Pennsylvania - UPenn 1.0 asketry, smeared with pinon gum, pointed atthe bottom so that it could be set upright in the ground or hung byleather thongs to a tree, suggested the form of this jar. One side ismade flat, so that it
1.0
BOTTOM TIER
By: hands orPosted:

asketry, smeared with pinon gum, pointed atthe bottom so that it could be set upright in the ground or hung byleather thongs to a tree, suggested the form of this jar. One side ismade flat, so that it

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Kappa Sigma - ΚΣ Fraternity at University of Pennsylvania - UPenn 1.0 ayin perfecting a piece of pottery—putting the final touch upon it: thetouch that shall make or mar—that the potter realises he must plan,before anything else, either to own a good kiln or to know of
1.0
BOTTOM TIER
By: olling-pPosted:

ayin perfecting a piece of pottery—putting the final touch upon it: thetouch that shall make or mar—that the potter realises he must plan,before anything else, either to own a good kiln or to know of

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
↓ Posts Continued Below ↓

NEW ON GREEKRANK

Kappa Sigma - ΚΣ Fraternity at University of Pennsylvania - UPenn 1.0 , the hands rise, until the top is reached. If theshape is not quite true, the hands start in the same position at thebottom and again go up, pressing hardest when pressure is needed, andgoing lightly
1.0
BOTTOM TIER
By: shaped mPosted:

, the hands rise, until the top is reached. If theshape is not quite true, the hands start in the same position at thebottom and again go up, pressing hardest when pressure is needed, andgoing lightly

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Kappa Sigma - ΚΣ Fraternity at University of Pennsylvania - UPenn 1.0 , for incising and other decorative work. A steel tool withnarrow, flattened ends (see Fig. 4) is necessary for cutting away thebackground to leave the design in low relief.[Illustration: FIG. 6][Illu
1.0
BOTTOM TIER
By: olved. IPosted:

, for incising and other decorative work. A steel tool withnarrow, flattened ends (see Fig. 4) is necessary for cutting away thebackground to leave the design in low relief.[Illustration: FIG. 6][Illu

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Kappa Sigma - ΚΣ Fraternity at University of Pennsylvania - UPenn 1.0 kes of the flat part of the thumb or forefinger nail.Where the coil joins the other end it is cut into a long, flat pointthat will fit exactly the point at the beginning, completing the row.[Illustrat
1.0
BOTTOM TIER
By: for thePosted:

kes of the flat part of the thumb or forefinger nail.Where the coil joins the other end it is cut into a long, flat pointthat will fit exactly the point at the beginning, completing the row.[Illustrat

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Kappa Sigma - ΚΣ Fraternity at University of Pennsylvania - UPenn 1.0 halves. Press the two outersurfaces together, kneading out the air-holes, which will be foundon the inner surfaces. This process repeated a number of times willfinally expel all the air-bubbles and le
1.0
BOTTOM TIER
By: same wayPosted:

halves. Press the two outersurfaces together, kneading out the air-holes, which will be foundon the inner surfaces. This process repeated a number of times willfinally expel all the air-bubbles and le

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report
Kappa Sigma - ΚΣ Fraternity at University of Pennsylvania - UPenn 1.0 l is in use which enables the potter to sit whileat work. This is the wheel shown in Fig. 11. It is obtainable frommakers of potters’ tools. The cost of such a wheel, with an iron topand shaft, and wo
1.0
BOTTOM TIER
By: h thesetPosted:

l is in use which enables the potter to sit whileat work. This is the wheel shown in Fig. 11. It is obtainable frommakers of potters’ tools. The cost of such a wheel, with an iron topand shaft, and wo

  • Reputation: PRO USERS ONLY
  • Friendliness:
  • Popularity:
  • Classiness:
  • Involvement:
  • Social Life:
  • Brotherhood:
Respond Report

YOU MAY ALSO LIKE

POPULAR ON GREEKRANK

Didn't find your school?Request for your school to be featured on GreekRank.